The Reid Racing, Inc. tailshaft housings are designed to fit both the REID Superglide and the stock GM Powerglide transmissions. 5 times stronger than stock, yet weighs only 4-1/2 pounds

• Bolt in replacement - length and crossmember mounting flange is exactly the same as stock
• Double lip seal
• Relocated vent puts an end to the problem of trans fluid spraying out of breather
• Completely pre-assembled
• Includes a hardware kit with everything you need to bolt it on

Model PGH1R $179
Powerglide Tailhousing with roller bearing - This model uses a needle rolling bearing to transfer maximum horsepower. A modified stock driveshaft yolk or special hardened undersize yolk is required (*see below)

Model PGH1B $179
Powerglide Tailhousing with bushing - Exact stock tailhousing replacement using a Teflon coated driveshaft yoke bushing; a stock powerglide type yoke can be used.

Model PGH2R $199
Powerglide Tailhousing with Turbo 400 roller bearing - This model is used when the Superglide has a Turbo 400 output shaft. The driveshaft yoke is supported by a roller bearing instead of a bushing. A special hardened oversize Turbo 400 yoke is required (see below).

Model PGH2B $179
Powerglide Tailhousing with Turbo 400 bushing - This model is used when the Superglide has a Turbo 400 output shaft. A standard Turbo 400 driveshaft bushing is installed and a stock Turbo 400 type yoke can be used (see below).

Special Note: No speedometer cable provision is supplied.

All yokes are made specifically for Reid Racing by Mark Williams:

Model PGYMW (yoke for PGH1 or PGH1R standard powerglide output shaft roller bearing tailhousing, 1350 u-joint) $219.00

*Note: Due to the precise dimension of the needle bearing, some yokes may need polishing to fit correctly. Accepts 1.497" - 1.499" O.D. yokes. Some yokes are produced at 1.502" to compensate for bushing wear. MEASURE YOURS!

Model PGYMW-400B (yoke for PGH2B Turbo 400 bushing tailhousing, 1350 u-joint) $219.00

Model PGYMW-400R (yoke for PGH2R Turbo 400 roller bearing tailhousing, 1350 u-joint) $219.00

Model PGYMW-400R-1480 (yoke for PGH2R Turbo 400 roller bearing tailhousing, 1480 u-joint) $335.00

Strange Engineering (847) 869-7010 also offers a special Yoke for the REID Racing PGH1R tail housing, Strange part #U1667N